 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
| . |  |
. |
QuikScat Checks Out
Washington - June 24, 1999 - QuikScat will fire its four onboard thrusters today in a "cluster" of five separate burns. The thrusters will fire for about 10 minutes beginning at 1 p.m. PDT, then will rest while the satellite orbits Earth twice, then fire again, continuing until the thrusters have fired a total of five times today.The thruster firings are designed to begin circularizing QuikScat's orbit and raise the perigee, or the closest point in its orbit to Earth. Each of the thrusters puts out 4.4 newtons (1 pound) of force. Commands to carry out the "cluster burn" have been generated at the University of Colorado's Laboratory for Atmospheric and Space Physics, Boulder, CO, which conducts satellite operations under the direction of engineers from Ball Aerospace & Technologies Corp., Boulder, CO, which built the satellite. The command sequence was to be sent early this morning to a station of NASA's Deep Space Network in Canberra, Australia, for transmission to the satellite. Today's series of firings will be the largest of five such cluster burns scheduled over the next week and a half. Following launch, QuikScat has followed an orbit that takes it as close as 290 kilometers (180 miles) to Earth's north pole; after today's firings, the satellite will pass within about 420 kilometers (260 miles) of the north pole. Today's cluster of firings will increase QuikScat's velocity by about 44 meters per second (100 miles per hour), causing the satellite to complete one orbit of Earth every 97 minutes at a speed of about 7.4 kilometers per second (16,500 miles per hour). Later cluster burns will continue to adjust QuikScat's orbit until the satellite is circling Earth at a fixed altitude of 800 kilometers (500 miles). They will change the orbit by progressively smaller amounts as the pressure in the satellite's propellant tank declines and thruster performance decreases. Later cluster burns are tentatively scheduled for about the same time of day on June 27, June 29, July 1 and July 3. Once the burns have circularized QuikScat's orbit, two or three small burns will be performed to perfect the final orbit size, shape and orientation for the start of the ocean-mapping mission. All satellite systems are operating normally. The satellite's scatterometer radar instrument is scheduled to be turned on and begin collecting and transmitting data on July 7. Members of the science team will spend about 13 days calibrating initial data before the primary mission of mapping ocean winds begins on July 19.
QuickSat At SpaceDaily
|
|
| ||||||||||
| The content herein, unless otherwise known to be public domain, are Copyright 1995-2016 - Space Media Network. All websites are published in Australia and are solely subject to Australian law and governed by Fair Use principals for news reporting and research purposes. AFP, UPI and IANS news wire stories are copyright Agence France-Presse, United Press International and Indo-Asia News Service. ESA news reports are copyright European Space Agency. All NASA sourced material is public domain. Additional copyrights may apply in whole or part to other bona fide parties. Advertising does not imply endorsement, agreement or approval of any opinions, statements or information provided by Space Media Network on any Web page published or hosted by Space Media Network. Privacy Statement All images and articles appearing on Space Media Network have been edited or digitally altered in some way. Any requests to remove copyright material will be acted upon in a timely and appropriate manner. Any attempt to extort money from Space Media Network will be ignored and reported to Australian Law Enforcement Agencies as a potential case of financial fraud involving the use of a telephonic carriage device or postal service. |
