The results indicate that missing cross-links between the individual carbon layers are responsible for the buckling. (Physical Review Letters, November 25, 2005). Such a finding has implications for the way high-tech carbon materials are produced.

High-strength, ultra-light and elastic carbon materials are commonly used in high-performance sports goods and modern aerospace technology - for example in tennis rackets, racing tyres, heat shields and even guitars. Carbon fibres are only a few micrometres thick and mainly used to mechanically reinforce other materials, like polymers, metals, and ceramics.

In tension, these kinds of fibres are stronger than most other known materials. However, compression applied parallel to the fibre axis can cause the buckling of nanoscale carbon layers - comparable to the buckling of a long, thin rod under compressive load.

In a novel physical experiment at the European Synchrotron Radiation Facility in Grenoble, researchers from Potsdam, Germany and Vienna have threaded both ends of micrometre thick carbon fibres through thin hollow needles in order to form fibre loops. The fibres are stretched on the outside of the loop and compressed on the inside. In-between there is a neutral zone, as we might find in a bent beam.

By tugging on the ends of the fibres, the scientists were able to adjust the loop's radius, and thus also the mechanical load in the tensile and the compression region.

Oskar Paris from the Max Planck Institute of Colloids and Interfaces explains that "what is unique about the experiment is that we can make observations at many length-scales and thus gather evidence about the secret of 'nano-buckling'. Using a 100-nanometre wide x-ray beam, we can scan the differently distorted regions along the cross-section of the fibre. Our nano-magnifier - the diffraction of the x-ray beam -allows us to measure the local strains of the only some nanometres thick carbon layers, as well as their orientation with respect to the fibre axis."

High-tech carbon fibres are made of graphite-like carbon sheets with strong covalent atomic bonding within the sheets, and weak Van der Waals bonding between them. Almost all the physical properties - and particularly mechanical behaviour - of these materials depend on their orientation.

Their tensile stiffness is as much as five times higher than that of steel, and their specific tensile strength can overcome that of steel by a factor of ten. Under compression, however, the fibres can fail. Here, the mechanical behaviour is determined by mechanical instability - carbon layers buckling at the nanoscale - in addition to the shearing of single carbon layers.

In spite of this, some carbon fibres exhibit astoundingly good shear properties. In these cases, "nano-buckling" is rarely observed - which suggests the existence of a substantial number of strong cross-links between the carbon layers. Herwig Peterlik from the University of Vienna explains that "if we could reinforce the usually very weak connections between the carbon layers in a controlled way using this kind of covalent cross-links, then in addition to carbon fibres, the highly-vaunted new carbon nanotubes would be almost ready to make the strongest ropes in the world."

This has been possible very recently with electron irradiation, which requires however a high expenditure of money and energy. The high price is also the major reason why carbon fibres, which are relatively cheap to produce, are not easily replaced by modern nanotubes. The question why these valuable cross-links occur only in some carbon fibres, while others buckle, still remains unclear.

Original work: Dieter Loidl, Oskar Paris, Manfred Burghammer, Christian Riekel and Herwig Peterlik. Direct observation of nanocrystallite buckling in carbon fibers under bending load. Physical Review Letters 95, 225501 (2005), November 2005.

Related Links
Max Planck Institute of Colloids and Interfaces
University of Vienna
European Synchrotron Radiation Facility
SpaceDaily
Search SpaceDaily
Subscribe To SpaceDaily Express

Thanks for being here; We need your help. The SpaceDaily news network continues to grow but revenues have never been harder to maintain. With the rise of Ad Blockers, and Facebook - our traditional revenue sources via quality network advertising continues to decline. And unlike so many other news sites, we don't have a paywall - with those annoying usernames and passwords. Our news coverage takes time and effort to publish 365 days a year. If you find our news sites informative and useful then please consider becoming a regular supporter or for now make a one off contribution.
SpaceDaily Contributor $5 Billed Once credit card or paypal		SpaceDaily Monthly Supporter $5 Billed Monthly paypal only